HumanCentric Cable Box Mount and Modem Mount | Adjustable Wall Mount for Small and Wide Devices Like Cable Boxes, Modems, DVD Players, Streaming Media Devices | Patented

February 22, 2020 - Comment

DESCRIPTION Our Adjustable Small Component Wall Mount (Wide) is custom designed to fit the following dimensions: Vertical Height: Maximum of 10″ (no minimum) Vertical Length: 3.5″ to 10″ Vertical Depth: 1.8″ to 2.9″ **If your device does not fit in the above dimensions, we offer other wall mounts for larger and smaller components!** COMPATIBLE MODELS

Buy Now! $19.99Amazon.com Price
(as of April 19, 2020 9:01 am GMT+0000 - Details)

DESCRIPTION

Our Adjustable Small Component Wall Mount (Wide) is custom designed to fit the following dimensions:

Vertical Height: Maximum of 10″ (no minimum)

Vertical Length: 3.5″ to 10″

Vertical Depth: 1.8″ to 2.9″

**If your device does not fit in the above dimensions, we offer other wall mounts for larger and smaller components!**

COMPATIBLE MODELS

Important Note: Check your dimensions before purchasing!

AT&T U-verse boxes, Comcast Xfinity Set boxes, Nintendo Wii, Select Roku Devices, Samsung Blu-Ray Players, Toshiba Players, Charter Spectrum boxes, HP Pavilion Mini, Verizon Fios Boxes, Directv Receivers, Dish DVRs, Swann NVR boxes, and many more devices!

FEATURES

Adjustable to fit a variety of devices – just tighten until the device is secure! Quick, easy, hassle-free installation Designed to allow easy access to the power button, output jacks and cables Includes the drywall screws and anchors

Comments

Anonymous says:

Worked perfectly to hide my cable box! Did exactly what I needed. Loved the screw adjustment for different width of cable boxes. It holds the box firmly and allows me to plug and unplug cables easily. Also allows access to the power switch when mounted correctly.

Anonymous says:

Perfect compliment for properly wall mounting an AT&T U-Verse Pace 5268AC Gateway This is EXACTLY what I needed to mount my AT&T U-Verse Pace 5268AC “Gateway” (Modem/Router combo) inside of a newly installed in-wall network/datacom panel. The AT&T installers used a terrible plastic mount and zip ties to hang this thing outside of our old network panel which at the time was too small to house this and several other IoT “hubs” that we use. Once we installed our new Leviton 36″ panel, this HumanCentric wall mount was fairly easy to install. To test fit the gateway, I loosened the central screw as far out as it would go, inserted the gateway into the sliding channel, and then slowly tightened the central screw until the gateway was securely elevated inside of my network panel. Makes for a nice clean look, doesn’t impede any ventilation or indicator lights on the gateway, and the gateway is easily accessible if I do need to remove it for any reason. Great product!

Anonymous says:

Good design, has a few cut corners and is smaller than expected. Purchased for my SteamLink to mount under a table. It’s underwhelmingly small. Wide or heavy devices may need two. It IS made of metal. It would have benefitted from some nylon washers under the lock nuts, and certainly should have come with some stick-on foam pads for the inside. Nothing I couldn’t add myself, but for the price I expected more. See my photo for an actual product picture (note: SteamLink device not included and added foam tape was done by me and not part of the product…treat it as a suggestion.)The instructions are a bit odd. To adjust the clamp, only turn the philips head screw; the nuts are permanently set and should not need adjustment.

Write a comment

*